- Record engine hours
- Run engine to bring oil to operating temperature
- Remove engine oil
- Remove oil filter
- Visually inspect hoses/clamps/belts
- Install new oil filter
- Refill crankcase with oil
- Run engine
- Check for proper oil level
- Clean bilge
- Spray with corrosion inhibitor
- Change drive oil
- Grease gimbal bearing
- Check steering system for loose, missing or damaged parts
- Lubricate cables and linkages
- Check batteries
- Verify gauge operation
- Inspect bilge pump
- Inspect blower operation
- Verify navigation light operation
- Verify horn operation
- Verify proper fluid levels
- Inspect skeg and prop condition
- Inspect engine for fuel, oil and water leaks
|
- Record engine hours
- Run engine to bring oil to operating temperature
- Remove engine oil
- Remove oil filter
- Visually inspect hoses/clamps/belts
- Install new oil filter
- Refill crankcase with oil
- Run engine
- Check for proper oil level
- Clean bilge
- Spray with corrosion inhibitor
- Check trans fluid
- Check steering system for loose, missing or damaged parts
- Check batteries
- Inspect battery cables
- Verify gauge operation
- Inspect bilge pump
- Inspect blower operation
- Verify navigation light operation
- Verify horn operation
- Verify proper fluid levels
- Inspect drain plug in/out of boat
- Inspect rudder and prop condition
- Inspect engine for fuel, oil and water leaks
- Check and clean sea strainer
- Check steering
- Check ballast system fill and dump
- Inspect belt, hoses, and motor mounts
|